Edit Adjuster Dialog

Top  Previous  Next

 

 

The Edit Adjuster dialog allows you to modify the behavior of adjusters that were previously created with the Connect to Adjuster dialog.  Open the Edit Adjuster dialog by clicking the magnifying glass icon to the right of any adjuster.

 

 

Adjusters-2

 

 

Adjusters-3

 

 

The following controls are available.

 

 

Control

Description

Name

Sets the name of the adjuster.

Order

Influences the adjuster's position in the Adjusters panel.  Adjusters with smaller Order values will appear before adjusters with larger values.  Adjusters with the same Order value will appear in alphabetical order.  Since all newly created adjusters receive a default Order of 0, adjusters will always appear in alphabetical order unless you modify their positions using this slider.

Type

Controls whether the adjuster has a standard numeric slider or a drop-down with custom options.  This option will only appear for numeric adjusters.

Accuracy

Specifies the accuracy of numeric adjusters.  This option will only appear for numeric adjusters.

Minimum

Specifies the minimum value of numeric adjusters.  By default numeric adjusters start begin at a value of 0, but if an adjuster with a negative range is desired, you may reduced the minimum value here.  This option will only appear for numeric adjusters.

Maximum

Specifies the maximum value of numeric adjusters.  By default numeric adjusters have a range from 0 to 100.  But if, for example, the adjuster represented an angle and a range of 0 to 360 was desired, increase the maximum here.  This option will only appear for numeric adjusters.

Adjusted Properties

Each property that an adjuster has been connected to is listed in this section.  Instead of hunting for the adjusted property in the node tree, you can click adjusted properties' Connect to Adjuster buttons directly in this section.  Additionally, the "Find Node" buttons can be clicked to automatically find and select the adjusted node in the Nodes tab.

 

 

 


Page URL: http://www.spiralgraphics.biz/genetica/help/index.htm?edit_adjuster_dialog.htm